Hi, im using PIC16F877A , and im using the compiler MikroC example Blinking LEDS in portC and it doesnt blink the leds ...
I use a universal programmer , here's a pic of the configurations .. .
all the connections are correct MCLR tied to VCC, VDD to 5V,VSS to GND , i use 11MhZ osc
Your .HEX file work for me, nothing really bad in your code. Double check your hardware and if your universal programmer is set to program the configuration fuses.
works like a charm .. I tested it on mikroe easypic board and also programmed using: https://www.oshonsoft.com/picprog.html (simple 13V parallel port programmer )
As pointed out by mister_e, it seems that the software is not configured to handle the config settings properly. Try reading the PIC as suggested; what value do you get?
The config word saved within the hex file is 0x3F7A (read with IC-Prog)