Few questions. We have a new design that we need to have produced. We are looking for both some prototype boards for final testing as well as production pieces.
1. Does anything have a good source or inexpensive boards both for our proto and production runs?
2. We would really like to have radiused corners on the boards to accommodate our machined inset areas. Would this typically drive the cost of quite a bit? Should we just keep the corners square and add a witness line with screen print and chamfer the corners?
1. Does anything have a good source or inexpensive boards both for our proto and production runs?
2. We would really like to have radiused corners on the boards to accommodate our machined inset areas. Would this typically drive the cost of quite a bit? Should we just keep the corners square and add a witness line with screen print and chamfer the corners?