I finished w/ a project on some PC board, and it looks sloppy cuz I got some solder in places I didn't want to. How can I clean it up? Also, I was wondering if there is anything that anyone has heard of or made that you can solder onto the board, and be able to interchange a certain component (a capacitor in this case). I've seen them for IC's, but I wen to Radio shack, and couldn't find them. Thanx
Also, I was wondering if there is anything that anyone has heard of or made that you can solder onto the board, and be able to interchange a certain component (a capacitor in this case). I've seen them for IC's, but I wen to Radio shack, and couldn't find them. Thanx
The ones for ICs you talk about are DIL (Dual-In-Line) sockets. You can also get SIL (Single-In-Line). You should be able to cut these up with a hacksaw, wire cutters etc. to make single sockets that you can soler into the board, then you will be able to change the component freely.
Alternativly, if you know that you will only want to choose from a few components, you could put the components into the board, and use a rotary switch to select between them.
during my college electronics subject days, we use to cut ic sockets to serve as "general purpose" component sockets. its virtually unlimited just use your imagination on it. 8)