Nigel's IR Tutorial

Status
Not open for further replies.

Beefer3

New Member
I have just finished the tutorial and I got to say, "what a great site Nigel!". I have one question about the IR tutorial. Can this circuit be amplified? The reason I ask is that I have an "All For One" remote and when I point this remote anywhere in my room, I can change the channel. But with Nigel's remote, I have to point this remote straight at the TV. It is a great circuit but I wish it had more power.

Any help?

Thanks
 

You could increase the LED current by reducing the value of the current limiting resistor - but it already works over 10m away. It could be the IR LED's you are using, you can get them with different beam widths, your's may be very narrow beam, and the OFA's very wide.
 
I have a quick question, what wave length is good to use for IR apps? I have some that are 935nm but i'm not really sure what the standard is or what the remote he was talking about might be using.
 
vaineo said:
I have a quick question, what wave length is good to use for IR apps? I have some that are 935nm but i'm not really sure what the standard is or what the remote he was talking about might be using.
Click to expand...

The ones listed as intended for IR remote control are usually 940-950nm.
 
Status
Not open for further replies.

Similar threads

J
  • Question
Trying to convert an IR Torch
Replies
7
Views
2K
schmitt trigger
S
V
IR Remote Control Fun
Replies
19
Views
4K
gophert
44-Key IR Remote NEC 'Command' Codes
Replies
0
Views
2K
Mike - K8LH
A
SainSmart TB6560 tutorial
Replies
1
Views
2K
Musicmanager
K
IR camera Distinguishing between two flashing IR leds?
Replies
0
Views
2K
kate90
K
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…