need help for my robot

[loard]

Hello everyone,
Iam trying to build a boebot robot
using bs2 microcontroller and white breadboard
I connect the microcontroller, servo motors to breadboard
and tried to make it move but it is not show any action
I want to build an education board using breadboard
The program in bs2 is fine, but the problem is in hardware, does it need more equipment
I want to know how to build my own board of education?
how can I do that, any helpful links?
can any one help me?
thanks

 

[blueroomelectronics]

I think your breadboard may not have continuous power rails.

Check for voltage on the servos.

 

[loard]

I connect the servo motors to 4 AA battries to produce 6v
and connect the VCC(VDD) pin of microcontroller to 3 AA battries 4.5v
as mentioned in BS2 manual :
VDD:
5-volt DC input/output: if an unregulated voltage is applied to the
VIN pin, then this pin will output 5 volts. If no voltage is applied to
the VIN pin, then a regulated voltage between 4.5V and 5.5V
should be applied to this pin.
but it is not working yet, why?