zacherynuk
New Member
Hello everyone!
I am hoping for some help, this is my first visit and post to this forum, so I apologise for lack of proper introduction.
I am trying to separate the light engine and video processing board from a pico projector – I would like to be able to house the video processing board some 20 – 200cm away from the light engine itself.
The components are far to small to solder, so I imagine I would have to try and find a connection convertor, or pre-fab extension cable.
Please see links to pictures.
http://www.wastedspace.co.uk/hmd/DMDConnector/P1020193.JPG
http://www.wastedspace.co.uk/hmd/DMDConnector/P1020197.JPG
http://www.wastedspace.co.uk/hmd/DMDConnector/P1020192.JPG
http://www.wastedspace.co.uk/hmd/DMDConnector/P1020196.JPG
Any and all help is greatly appreciated, I am way out of my knowledge zone here!
Thanks,
Zach
I am hoping for some help, this is my first visit and post to this forum, so I apologise for lack of proper introduction.
I am trying to separate the light engine and video processing board from a pico projector – I would like to be able to house the video processing board some 20 – 200cm away from the light engine itself.
The components are far to small to solder, so I imagine I would have to try and find a connection convertor, or pre-fab extension cable.
Please see links to pictures.
http://www.wastedspace.co.uk/hmd/DMDConnector/P1020193.JPG
http://www.wastedspace.co.uk/hmd/DMDConnector/P1020197.JPG
http://www.wastedspace.co.uk/hmd/DMDConnector/P1020192.JPG
http://www.wastedspace.co.uk/hmd/DMDConnector/P1020196.JPG
Any and all help is greatly appreciated, I am way out of my knowledge zone here!
Thanks,
Zach