Micro Connector Identification and Extension Cable Creation

Hello everyone!

I am hoping for some help, this is my first visit and post to this forum, so I apologise for lack of proper introduction.

I am trying to separate the light engine and video processing board from a pico projector – I would like to be able to house the video processing board some 20 – 200cm away from the light engine itself.

The components are far to small to solder, so I imagine I would have to try and find a connection convertor, or pre-fab extension cable.

Please see links to pictures.

http://www.wastedspace.co.uk/hmd/DMDConnector/P1020193.JPG

http://www.wastedspace.co.uk/hmd/DMDConnector/P1020197.JPG

http://www.wastedspace.co.uk/hmd/DMDConnector/P1020192.JPG

http://www.wastedspace.co.uk/hmd/DMDConnector/P1020196.JPG

Any and all help is greatly appreciated, I am way out of my knowledge zone here!

Thanks,

Zach