Making Vero board with Eagle ?

april

Member

• Mar 8, 2013

• #1

I have had a bit of a go at this .- see attached Eagle file
I want to be able to design stuff on a vero board but could not find a part or board to use in the library.

Anyone already done this ?
What parts or info are you using ?

 

Attachments

• Veroboard.brd

  44.3 KB · Views: 562

jpanhalt

Well-Known Member

Most Helpful Member

• Mar 8, 2013

• #2

That is a good start, but cutting the conductors may be complicated, depending on how you made them.

Here are two programs that may be more suited to what you are trying to do.

https://diy-fever.com/software/
https://fritzing.org/

John

 

K

kubeek

Well-Known Member

Most Helpful Member

• Mar 9, 2013

• #3

when I last did that, I simply set the grid to 100mil and started placing components, placing traces one way and jumpers the other way, and leaving one grid point between traces to make the cut.

 

S

shortbus=

Well-Known Member

Most Helpful Member

• Mar 9, 2013

• #4

there's also these - http://www.printedcircuitsboards.com/software/88/veroboard-stripboard-software.html

 

april

Member

• Mar 13, 2013

• #5

Thanks all !