S Slicer New Member Mar 13, 2016 #1 Hi folks, I'm new to this, I've got an issue with this loose connector and wondered if anyone had a schematic so I could: a) make some form of permanent wiring. b) use a different type of connector set up. would need the wire colours too? Any help would be much appreciated
Hi folks, I'm new to this, I've got an issue with this loose connector and wondered if anyone had a schematic so I could: a) make some form of permanent wiring. b) use a different type of connector set up. would need the wire colours too? Any help would be much appreciated
Ramussons Active Member Mar 14, 2016 #2 To start with, why not open the box and use a ohmeter to identify which pins terminate where... It will be a good starting point.
To start with, why not open the box and use a ohmeter to identify which pins terminate where... It will be a good starting point.
Ramussons Active Member Mar 23, 2016 #4 Googling gave this ... https://www.fixya.com/support/t14220961-logitech_z3_wiring besides a lot more.
Googling gave this ... https://www.fixya.com/support/t14220961-logitech_z3_wiring besides a lot more.