Kenmore range timer board burnt resistor

Hello all

I have a timer board from a Kenmore range model 970-687632. On the timer board, R1 is burnt beyond recognition. The board number is 3164627 Revision G.

Anyone familiar with this repair or have access to schematics? It is a common problem apparently. Just looking for the value of the resistor, R1. This site lists similar issues. Perhaps the burn due to a power surge?


Thanks
Shawn

One of the "Repaired" entries in that list says R1 is 220 Ohms??

Not necessarily the same board, but worth consideration?

says its 221 ohms 1 %,,,

Thanks Ramondo (interesting read) and rjenkiinsgb

I guess I scanned that list a little too quickly. After I posted this question, I kept looking at images for that board and found some that looked like R1 was a 220 ohm ( 1 looked 270 and one other looked very different. ) My friend who owns it had grabbed a few resistors locally, (not knowing what he was getting) but ended up with the 270 (which he thought it was) and a 220 1 watt. I put the 220 in due to its higher power rating and the fact that I found images with a 220 in there. It is currently working but time will tell. From the link posted above though, I am less than optimistic.

Thank you for the input.
Regards,
Shawn