JuneBug Target Board ICD Query

[UTMonkey]

I posted a question some time ago about the possibility of programming a PIC on a target board from my JuneBug.

The response was "but of course you can - ICSP!" (silly me).

My next question is, could I debug a PIC in a target board from my Junebug (ICD)?

Regards

Mark

 

[blueroomelectronics]

"but of course you can - ICD!"

 

[August Treubig]

JuneBug is PicKit 2

I do it (well not every day) all the time. I only built the programmer half of the Junebug, so all I have is the 10 pin connector going off board. I have built several of Nigel's boards, adding an ICSP socket to them. 16F648A, 16F877A, 18F1320, 18F4450, etc. Program or Debug. (Well not the 648A).

 

[UTMonkey]

Great!

Do I have to change the dip switches?

Mark

 

[blueroomelectronics]

Yep, 1,2,3 off will separate the tutor from the ICD connector.