M makemyday New Member Apr 12, 2019 #23 Pommie said: No, that will not work. Put a 10k to 5V so the transistor is held on and a 1k to your pin so the Gnd (pin low) can turn the MOSFET on (transistor off). Mike. Edited. Click to expand... I will try your suggestion. Thank you Mike and also Gophert for helping.
Pommie said: No, that will not work. Put a 10k to 5V so the transistor is held on and a 1k to your pin so the Gnd (pin low) can turn the MOSFET on (transistor off). Mike. Edited. Click to expand... I will try your suggestion. Thank you Mike and also Gophert for helping.
P Pommie Well-Known Member Most Helpful Member Apr 12, 2019 #25 A 10k base resistor is a little on the high side but, yes, just change the 100k for a 1k. Mike.