Identify connector for coaxial cable

T

takachan

New Member

• Jan 20, 2012

• #1

I need some help to identify what type of connector is this. This connector was initially installed 30 years ago with a coaxial cable(unknown type) which was replaced by 75 ohms, coaxial RG11.
Thanks in advance.

 

cowboybob

Well-Known Member

Most Helpful Member

• Jan 21, 2012

• #2

Not sure.

What sort of equipment is it in?

Whatever it is, it might be worth your while to replace it with an SO-239 type, which is probably a lot for readily available.

 

debe

Active Member

• Jan 21, 2012

• #3

Its a typical 75ohm TV type aerial conector found on the rear of a TV set.

 

4pyros

Well-Known Member

Most Helpful Member

• Jan 21, 2012

• #4

Can't realy see the photo. is it a push in type?

 

T

takachan

New Member

• Jan 21, 2012

• #5

Thanks for your replies.
Yes this is push in type connector, the inner conductor is compatible with PL259, but the external conductor can't be connected.
It's used to connect a impulse signal(<500V) to an oscilloscope.
Thanks.