I NEED CODE FOR 8051 SERIAl comm..PLSSS HELP

;All baud rates @ 11.0592 MHz
.EQU	BAUD_CONST,	250		; 9600 BAUD

.EQU OLD_DATA, 0x30
.EQU NEW_DATA, 0x31

;********************************************************************************
.ORG	0000H
	LJMP MAIN

.ORG	0023h		; SERIAL I/O INTERRUPT VECTOR
	LJMP UART_INTR
;**********************************************************************************

;**********************************************************************************
; PROGRAM ENTRY POINT
;**********************************************************************************
MAIN:
	CLR	ACC
	MOV	NEW_DATA, A
	MOV	OLD_DATA, A
	LCALL	INIT_SERIAL

MAIN_LOOP:
	MOV	NEW_DATA, P2
	MOV	A, OLD_DATA
	XRL	A, NEW_DATA
	JZ	MAIN_LOOP
	MOV	OLD_DATA, NEW_DATA      ; Send character if data is changed on P2
	MOV	SBUF, NEW_DATA
	SJMP	MAIN_LOOP


;***********************************************************************************************
; INITIALIZE SERIAL PORT
;***********************************************************************************************
INIT_SERIAL:
        CLR     EA
        ORL     PCON, #10000000B        ;SET DOUBLE BAUD RATE
        ANL     TMOD, #00001111B        ;CLEAR ALL TIMER1 BITS IN TMOD
        ORL     TMOD, #00100000B        ;SET TIMER1 AS 8 BIT AUTO RELOAD
        CLR     TR1                     ;MAKE SURE TIMER1 ISN'T RUNNING
        CLR     TF1
        MOV     A, #BAUD_CONST          ;256 - (CRYSTAL / (BAUD * 192))
        MOV     TH1, A                  ;SET TIMER1 RATE
        MOV     TL1, A
        MOV     SCON, #01010000B        ;CONFIG SERIAL PORT (RI AND TI CLEARED) MODE=1
        SETB    TR1                     ;START TIMER1
        SETB    ES                      ;ENABLE SERIAL PORT INTERRUPT
        SETB    EA                      ;ALSO TURN ON INTERRUPTS IN GENERAL
	SETB	PS			;SET SERIAL PORT PRIORITY LEVEL 
        RET

;**********************************************************************************
; SERIAL PORT INTERRUPT SERVICE ROUTINE
;**********************************************************************************
UART_INTR:
GetChar:
	PUSH	PSW
	PUSH	ACC
	JB	TI,TRANSMIT_1
	JNB	RI,GetChar
	MOV	P1, SBUF ;Send Character to P1
	CLR	RI
	SJMP	INTR_END
TRANSMIT_1:
	CLR	TI
INTR_END:	
	POP	ACC
	POP	PSW
	RETI