I'm using an ADC and i wanna first test its workability. Im trying to test it on a stand alone, wonder if any load effect will occured. i dun seems to get any output.
I using AD7478 and TLC0832, both are 8 bits serial out. dun seems to get any output if i connect to the infor on pins shown in the spec sheet. what shd i do?
I'm using an ADC and i wanna first test its workability. Im trying to test it on a stand alone, wonder if any load effect will occured. i dun seems to get any output.
I using AD7478 and TLC0832, both are 8 bits serial out. dun seems to get any output if i connect to the infor on pins shown in the spec sheet. what shd i do?
Make sure you are clocking the converter correctly. Look at the serial output with an O'scope and make sure it is putting bits out. If it is, then you have a receive problem. If it is not, you could have a clocking or power supply problem.