Hi guys, i'm making an H-Bridge motor driver for a water gun turret. The idea is that when i send a 5v signal to one side it turns the motor one way and when i send a signal to the other side it turns the other way. Quite simple really and i'm sure everyone's seen an H-bridge before.
Anyway this is my problem:
-Testing it out on Multisim there were no problems at all
-Building it on the PCB and testing it caused the TIP 125's to blow up
This wasn't expected. I've uploaded a PDF with my testing on Multisim and my circuit design for it, if anyone could point out any glaring mistakes for me i'd greatly appreciate it.
Cheers
Anyway this is my problem:
-Testing it out on Multisim there were no problems at all
-Building it on the PCB and testing it caused the TIP 125's to blow up
This wasn't expected. I've uploaded a PDF with my testing on Multisim and my circuit design for it, if anyone could point out any glaring mistakes for me i'd greatly appreciate it.
Cheers
Last edited: