C crust Member Nov 22, 2003 #2 You could put a resistor across it, but that might take a very long time. I would just put a rubber band across the drill trigger (if you still have the drill). Otherwise, a light bulb (particularly a bright one) works well.
You could put a resistor across it, but that might take a very long time. I would just put a rubber band across the drill trigger (if you still have the drill). Otherwise, a light bulb (particularly a bright one) works well.
R RED02 New Member Nov 22, 2003 #3 tried a light bulb but it still takes a long time, is there anything that would be quite quick?
C crust Member Nov 22, 2003 #4 A motor with a load would drain it quickly ... getting the load on there would be difficult though. Maybe the headlight of a car ...
A motor with a load would drain it quickly ... getting the load on there would be difficult though. Maybe the headlight of a car ...