And depending on what part of the circuit they are in, could probably all be replaced with 1uF - remember, back then electrolytic capacitors had huge tolerances - in the 20 to 80% range (some of today's are not much better).
Many years ago I repaired several Sanyo color tv's made in 1974 and up and these exact capacitors were used in all of the sets I worked on and Augustinetez and Nigel are correct on the values. In fact I had to replace a .47uf electrolytic capacitor in the AGC circuit of one tv. The tv had a bunch of horizontal white lines in the picture on active channels only. All the lines started on the left side of the screen and extended anywhere from 1/4 to 2/3 across. Picture was normal beyond the lines. It took me a while to figure out the problem and find the defective part was the little electrolytic. I had another used one on hand salvaged from a scrapped set.
While the light blue Sanyo caps were famous for drying up, Looks like you have a bit more on your hand than Sanyo caps....
I am very familiar with that era... I can certainly spot the same thing in your posted pix
Pay close attention to the darker areas on the board as you will notice some of the Electolytics have been slowly leaking out.(mostly from the cathode lead). It makes an absolute mess. Not only it is conductive, it is also very corrosive, etching traces and capillaries up the adjacent component legs.--(watch out for the smell as you begin to de-solder). The left-over liquid could easily act like a massive resistor pad under components and you may have to pull components
Look up the series number on the leaky cap and if there are used elsewhere on the board, it is just a matter of time before they will leak and make a mess. If you happen to have an odd servo &/or video problem, it can easily send you thru a wild goose chase.
In US, back in the 80's, many of the Consumer Electronics were plagued with leaky caps.