hello

[imisendo_4036]

can anyone xplain...my prob is

i hav connect 7 led to pic port b...
i've already declare port b as output...
but once i run my simulation...all leds are on...
suppose it should display juz one led on at one time...
and 4 teh info....the led show the speed the motor running at..

 

[AtomSoft]

Can you write in english ? na but i can barely understand it. Also If its code related can you post the code your using?

 

[imisendo_4036]

dc motor speed controller.....

i've declare port B as output...
but once i run my simulation...all led that connected to port B are on...
suppose it should display just one led on at one time...
and 4 the info....the led will indicate the speed the motor running at..
means my motor have seven speed only.

**broken link removed** is the link

i've follow the step that shown in that site......but still got problem