Hero999
Banned
Are you talking about the hold-off?
Set that to a minimum.
I suppose you're right, there will be a short delay between triggering and a trace but if the frequency is very low, it will be negligible.
So on reflection 1MHz is probably too high. I normally use the mains frequency to calibrate my 'scope and I do so in the manner I described above so the hold-off effect should be minimal.
Set that to a minimum.
I suppose you're right, there will be a short delay between triggering and a trace but if the frequency is very low, it will be negligible.
So on reflection 1MHz is probably too high. I normally use the mains frequency to calibrate my 'scope and I do so in the manner I described above so the hold-off effect should be minimal.