Getting 'program' off pic and saving in mplab ide

Angry Badger

Member

• Dec 26, 2010

• #1

Hi,

Is it possible to grab the program off an 'unprotected' pic and save it through the mplab interface? If so could you tell how. I can read the device just not sure how to save it.

Thanks in advance for any help.

 

Last edited: Dec 26, 2010

blueroomelectronics

Well-Known Member

• Dec 26, 2010

• #2

Yes, just read the chip. It'll be in .hex format not source code.

 

Angry Badger

Member

• Dec 26, 2010

• #3

Hi blueroom,

was editing post while you replied Can't see where file is / how to save it.

 

Last edited: Dec 26, 2010

blueroomelectronics

Well-Known Member

• Dec 26, 2010

• #4

Can you use the PICkit2 software? It's one button.

It should be in the programmer menu in MPLAB

 

Last edited: Dec 26, 2010

Angry Badger

Member

• Dec 26, 2010

• #5

Hi,

Dont have that installed at moment. Sorted it anyway - view program memory then output to file. Have been in real hurry

Thanks for your help! Best regards, AB

 

Noggin

Member

• Dec 27, 2010

• #6

Or click on File -> Export