enable schmitt trigger in pb6 and pb7 for PIC

Status
Not open for further replies.
You don't enable them... they just are...In the I/O Ports section of the datasheet will tell you which are ST and which are just TTL and which are ONLY schmitt when programming (RB6 / 7)
 
Last edited:
Status
Not open for further replies.

Similar threads

B
  • Question
Temperature controlled fan using PIC16F877a (in assembly language)
Replies
4
Views
778
Dan Soze
D
  • Question
Using RD16 16BIT PIC register write in Oshonsoft
Replies
15
Views
2K
camerart
J
  • Question
Does J1939 standard require ECU to transmit binary one's for unused signals in a J1939 message?
Replies
15
Views
2K
jani12
J
  • Question
Low-Power Timer1 Oscillator Enable
Replies
6
Views
8K
Peet19
A
  • Question
Solved PIC Frequency counter - Interesting quandary
2
Replies
23
Views
3K
Mike - K8LH
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…