cyb0rg777
New Member
I took apart a broken motorola 120t cell phone and got out the lcd .
I found a rubber strip on the back making contact with pads on the circuit board.
I can't think of a way to attach wires or make any connection without making a pcb.
Does anyone have any other way of dealing with this?
Has anyone had any success with these lcds?
Do they run on 3.3v?
It would be awesome to get one into an empty drive bay on my pc,or in another project.
Thanks.
I found a rubber strip on the back making contact with pads on the circuit board.
I can't think of a way to attach wires or make any connection without making a pcb.
Does anyone have any other way of dealing with this?
Has anyone had any success with these lcds?
Do they run on 3.3v?
It would be awesome to get one into an empty drive bay on my pc,or in another project.
Thanks.