I'm not certain if it can be used for non-Stellaris chips, but I'm going to give it a try. Crossworks supports the Stellaris ICDI JTAG porgrammer. I'll check to see if it works on one of my other devices. Something tells me it won't support a non-Stellaris hardare ID. The st-link v2 does not seem to work with my LPC devices.
I don't have any interest in the C2000's so I don't have an evaluation board. I used to use Stellaris when they were Luminary Micro, but that was a long time ago when CM3 was brand new. This board will use either JTAG or SWD. SWD is a reduced pin count interface that's supported by CM0, CM3, and CM4 devices. 6 pins if you include power ground and reset.
Put my order in on 01/09 and received it 02/11. It is going onto the shelf for now until I find an alternative to the 1.3GB Code Composer studio download. What does that install as? I don't know if the installation needs to be validated over the internet. I don't have direct internet access on my PC, I run internet on a XP virtual machine.
Still kit looks pretty sweet for the price.
From my previous experience, you need the microcontroller edition, it's only around 300mb I think. That 1.3GB edition is the full DVD edition, and it's a bit messy to be installed. Have you installed it?
Installer definitely accessed the internet while installing. Not certain for what reason, though.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?