wuchy143
Member
Hi All,
I'm working on a design which is going to consist of two PCB's. The first board is the dummy board and the board with the brains will be the module board. Due to space constrictions the module board is going to sit vertically on the dummy board. I'm trying to figure out the best connector system to use in this application.
I have .613" for a height restriction as anything higher than that will start crashing into the metal ceiling.(top plate)
I was wondering if anyone had some good recommendations for some type of edge to edge style connector to terminate the module PCB to the dummy PCB. I've never needed to use this style of edge to edge connectors so I'm trying to find the one appropriate for my application.
I attached a simple drawing of what I am talking about.
Any guidance would be appreciated.
Thanks.
I'm working on a design which is going to consist of two PCB's. The first board is the dummy board and the board with the brains will be the module board. Due to space constrictions the module board is going to sit vertically on the dummy board. I'm trying to figure out the best connector system to use in this application.
I have .613" for a height restriction as anything higher than that will start crashing into the metal ceiling.(top plate)
I was wondering if anyone had some good recommendations for some type of edge to edge style connector to terminate the module PCB to the dummy PCB. I've never needed to use this style of edge to edge connectors so I'm trying to find the one appropriate for my application.
I attached a simple drawing of what I am talking about.
Any guidance would be appreciated.
Thanks.