# Eagle pin numbers - my new part

Status
Not open for further replies.

#### futz

##### Active Member
I'm designing a board in Eagle (5.3.0) and am having a small problem. I've built a new part (3M Micro SD socket) and it's all working fine except I can't figure out how to get my pins to show as 1,2,3... instead of P$5,P$6,P\$7...

Here's what I get:

Obviously I want the pins to be numbered like the MAX3232CSE above it. What am I missing?

#### Pommie

##### Well-Known Member
You have to rename them in the library package editor by clicking the toolbar button with resistor R2 on it.

Mike.

#### futz

##### Active Member
You have to rename them in the library package editor by clicking the toolbar button with resistor R2 on it.
That's what I thought at first, but that changes the names DAT2, CD/DAT3, etc. It doesn't change the pin numbers.

EDIT: Oops! I see what you mean now. I was trying to do it in the symbol editor. You are correct sir! Thanks very much!

Last edited:

#### Pommie

##### Well-Known Member
Are you in the symbol editor instead of the package editor.

Mike.

#### futz

##### Active Member
Are you in the symbol editor instead of the package editor.
I was. My bad. That's why the EDIT in my post above.

Status
Not open for further replies.