Hi chamil,
disable all layers not needed to display pads, vias and traces.
Disable layer19 (Unrouted), layer21 (tPlace), layer23 (tOrigins), layer25 (tNames), layer27 (tValues), layer43 (vRestrict) and layer51 (tDocu).
After that you should have left layers16 (Bottom, 17 (Pads), 18 (Vias) and 20 (Dimension).
Eagle is WYSIWYG (What You See Is What You Get).
When you have a clean display of pads and traces you might print your design.
The "Display" button is at the upper left hand corner marked red-blue-green.
Boncuk