Guys I am trying to use an ATtiny2313 MLF package in my project.
I could not find the proper device alread done. So I tred to add my own. Following the guide on eagles site. i created the part in schemtic editor adding the pins. and naming them.
Then I created the package.
Then I matched the pins to the pads when creating a device.
When I add my new device to the drawing and run lines to the other components, the airwave lines don't show up! And when I choose "Show" and click the pad I want to connect to the new device the appropriate pad does not chow up.
Anyone got a better guide? Or any ideas. Attached is a copy of the library.
ThankS
I could not find the proper device alread done. So I tred to add my own. Following the guide on eagles site. i created the part in schemtic editor adding the pins. and naming them.
Then I created the package.
Then I matched the pins to the pads when creating a device.
When I add my new device to the drawing and run lines to the other components, the airwave lines don't show up! And when I choose "Show" and click the pad I want to connect to the new device the appropriate pad does not chow up.
Anyone got a better guide? Or any ideas. Attached is a copy of the library.
ThankS