ProFPGA
Banned
Hi , i am using CME11E9-EVBU (its the MC68hc11 eval board ), in single chip mode .
I wrote a code for a delay of 30sec but i measured time when hc11 would dec port b after the said delay , it turns out to be 8.8sec .
After calculating cycles in my loop i am not running my code at 0.5usec each cycle ???
on the board i can see its a 8mhz crystal , so E clock should be 2mhz .
Any ideas ???
I wrote a code for a delay of 30sec but i measured time when hc11 would dec port b after the said delay , it turns out to be 8.8sec .
After calculating cycles in my loop i am not running my code at 0.5usec each cycle ???
on the board i can see its a 8mhz crystal , so E clock should be 2mhz .
Any ideas ???
Last edited:
