Continue to Site

Welcome to our site!

Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

Register Log in
  • Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

Driving our full bridge inverter

Status
Not open for further replies.
K

kken6248

New Member
We are trying to drive our full bridge inverter with a mosfet driver (HIP4082) connected to a SG3525 PWM chip. For some reason I think the frequency @ 60 Hz coming out of the Sg3525 is too low and the sync pin (Sg3525) may be acting differently then we want it to. We are trying to produce a 60 HZ sine wave. Any possible suggestions that can help me?
 
Status
Not open for further replies.

Similar threads

Athosworld
  • Question
Driving Transformer Help
Replies
14
Views
869
Athosworld
Athosworld
A
TL072 and Non-inverter small signal amplifying
2 3
Replies
43
Views
5K
arvinfx
A
V
  • Question
Analog or gate
Replies
3
Views
764
Tony Stewart
Tony Stewart
E
  • Question
H-bridge driver board with input for direction
Replies
4
Views
2K
Erhy
E
H
  • Article
Precision Voltage-to-Frequency Converter,100 kHz Full-Scale, ±0.03% Non-Linearity
Replies
14
Views
2K
Lightium
Lightium

Latest threads

New Articles From Microcontroller Tips

Back
Top