gechihoney
New Member
Hi, i was given these equipment to design a dual rail dc Power Supply:
2 off diodes (IN4001) 2 off Zener diodes
2 off Resistors (1 kΩ) 2 off Capacitors (1 μF)
1 off Oscilloscope, DVM, AC supply source ( ±12V)
Using an appropriate selection of the components listed above, design and construct a direct voltage supply having two outputs, one positive and one negative.
Im not too sure how to go about it, plssss helppp.. Thanks
2 off diodes (IN4001) 2 off Zener diodes
2 off Resistors (1 kΩ) 2 off Capacitors (1 μF)
1 off Oscilloscope, DVM, AC supply source ( ±12V)
Using an appropriate selection of the components listed above, design and construct a direct voltage supply having two outputs, one positive and one negative.
Im not too sure how to go about it, plssss helppp.. Thanks