Hi,
I have an LG Scanworks 66a scanner, wich doesnt pull back the scanning head.
I always have to unscrew the motor and pull back manually after each scan.
I have measured the signal from the ir-bridge to the processor, and everything is fine.
Cant be a driver problem, because it does nothing (no initialization) when i power on the unit. (with or without a parallel cable plugged in)
Any idea on what could be wrong?
Thanks in advance.
I have an LG Scanworks 66a scanner, wich doesnt pull back the scanning head.
I always have to unscrew the motor and pull back manually after each scan.
I have measured the signal from the ir-bridge to the processor, and everything is fine.
Cant be a driver problem, because it does nothing (no initialization) when i power on the unit. (with or without a parallel cable plugged in)
Any idea on what could be wrong?
Thanks in advance.
Last edited:
