M mesamune80 New Member May 18, 2009 #1 Hi all, Anyone here come across this stepper motor driver ? It is from oriental motor japan.i am using PIC16F877 to send signal a pulse and direction signal to this driver but the direction control for this driver seem quite different from what we have normally which direction is controlled by high and low signal.For this it needs both signal pulse to rotate the steppper motor. ;( need to know how to drive my motor.. By the way i am using vexta motor which is PK566-NB below is the link to datasheet:https://www.electro-tech-online.com/custompdfs/2009/05/vextajpncskmanual.pdf Thanks
Hi all, Anyone here come across this stepper motor driver ? It is from oriental motor japan.i am using PIC16F877 to send signal a pulse and direction signal to this driver but the direction control for this driver seem quite different from what we have normally which direction is controlled by high and low signal.For this it needs both signal pulse to rotate the steppper motor. ;( need to know how to drive my motor.. By the way i am using vexta motor which is PK566-NB below is the link to datasheet:https://www.electro-tech-online.com/custompdfs/2009/05/vextajpncskmanual.pdf Thanks
M mesamune80 New Member May 19, 2009 #2 Hi everyone ,i just figured out how to run my motor this is what i did: CW: send a continuos pulse to + (positive terminal)CW Pulse input pin CCW:send a continuos pulse to + (positive terminal)CCW Pulse input pin That's all just share it out for those who need it Good Day!
Hi everyone ,i just figured out how to run my motor this is what i did: CW: send a continuos pulse to + (positive terminal)CW Pulse input pin CCW:send a continuos pulse to + (positive terminal)CCW Pulse input pin That's all just share it out for those who need it Good Day!