I simulated some Bode-plots for crossovers (high/low pass) in Multisim and it went ok for bandpass, low- and highpass.
Can I simulate, what happened, if I joined the Bode-plots. I.e. I have the low end, mid range and high end for some speakers. Now I would to overlay them, because I am aiming for 1 or so dB rise, where the mid is taking over. Its not exactly linear, so I try to lift the ends a bit.
Linear amp filter response can be added, yes , even if the response is not linear but passive filters may interfere impedance wise on response in parallel.
seems cannot be done, when the outputs of the 3 filters are connected, the result is more or less a line. Putting small resistors in at the outlet and place bode plotters before each resitor and another one to the sum of the outlets did not help either
Not sure why you started a new thread when you already had one dealing with this topic?
As I pointed out in the new thread, here, plotting the Bode plot of cascaded filters is the same as multiplying the individual responses, not adding them.