Hello all:
Is there any rule of thumb for the proper sized capacitor after the bridge rectifier in a regulated power supply. I will be using a LM350 as a regulator.
The required voltage will be set for approx 12v and I may push up to 3 amps. I was thinking of using a 4700uf cap rated for 25 volts. The power supply will be used to run some 12 volt muffin fans, so i don't think noise is that great of a concern.
Comments
-=Bryan=-
Is there any rule of thumb for the proper sized capacitor after the bridge rectifier in a regulated power supply. I will be using a LM350 as a regulator.
The required voltage will be set for approx 12v and I may push up to 3 amps. I was thinking of using a 4700uf cap rated for 25 volts. The power supply will be used to run some 12 volt muffin fans, so i don't think noise is that great of a concern.
Comments
-=Bryan=-