Cadsoft Eagle 'consistency' warning

[vinodquilon]

See the attachment.
How can I make board and schematic consistent, so that changes on one affects other?

 

[vinodquilon]

See the attachment.
How can I make board and schematic consistent, so that changes on one affects other?

The warning message is linked below...

 

[Wond3rboy]

For this the Board and Schematic have to be opened at the same time. Go through this, see 8

 

[3v0]

If you keep the board and the schematic open the program will keep them consistent.

If you close one and make changes to the other you are in trouble.

The msg tells you what is inconsistent. If you have only made a change or two you may be able to undo them to get to where they are consistent. If not remove the board file and create a new one for the schematic.

After you do this once or twice you will lean not to do what hurts.

3v0

 

[Boncuk]

Open the error list and acknowledge the changes done either to the board or the schematic.

This will clear the errors and schematic and board are consistent again.

No problem with newer Eagle versions.