Hi @ all,
I was able to set up my programmer, so that I can program the at89s51.
I'm trying to get a couple of leds blinking.
Now my question:
Should I connect the leds from VCC to a PORT
or
should I connect the leds from PORT to GND?
Are there any differences/advantages/disadvantages of one method?
sb42
I was able to set up my programmer, so that I can program the at89s51.
I'm trying to get a couple of leds blinking.
Now my question:
Should I connect the leds from VCC to a PORT
or
should I connect the leds from PORT to GND?
Are there any differences/advantages/disadvantages of one method?
sb42