Wond3rboy
Member
Hi, this is really embarassing to ask something like this but since i have done a lot of such things so here goes nothing:
This is the code:
This code blinks the LED in Debug mode of the Junebug.But when i do it on hardware then nothing happens. As seen in the code i have used the internal 4Mhz oscillator. Prescaled timer0 by 8. I used a 10k(also tried 1k) resistor to Vdd on MCLR(to use POR). I cant figure out what the hell is wrong with the hardware.
Is there something missing, tried timer and all the other general programs in debug mode and all went well but none run in hardware.
This is the code:
Code:
list p=18f1320
include <p18f1320.inc>
config osc=INTIO2,wdt=off
org 0
movlw 0X7F
MOVWF ADCON1
MOVLW B'01100000'
MOVWF OSCCON
bcf TRISA,1
movlw 0x02
movwf T0CON
AGAIN:
Btg LATA,1
movlw 0x00
movwf TMR0H
movlw 0x00
movwf TMR0L
bcf INTCON,TMR0IF
bsf T0CON,TMR0ON
DELAY:
btfss INTCON,TMR0IF
bra DELAY
bcf T0CON,TMR0ON
bra AGAIN
ENDThis code blinks the LED in Debug mode of the Junebug.But when i do it on hardware then nothing happens. As seen in the code i have used the internal 4Mhz oscillator. Prescaled timer0 by 8. I used a 10k(also tried 1k) resistor to Vdd on MCLR(to use POR). I cant figure out what the hell is wrong with the hardware.
Is there something missing, tried timer and all the other general programs in debug mode and all went well but none run in hardware.