beakie
New Member
I am building a pcb.
I want to utilise the ATmega328 and the arduino language but don't want to use an actual arduino in the circuit.
I intend to program the chip using my arduino and then take the chip and put it on a board in a minimal (non-ICSP) board.
Is there an eagle schematic people use or is it as simple as connecting the +5V and ground pins? What about clocks etc?
Cheers
I want to utilise the ATmega328 and the arduino language but don't want to use an actual arduino in the circuit.
I intend to program the chip using my arduino and then take the chip and put it on a board in a minimal (non-ICSP) board.
Is there an eagle schematic people use or is it as simple as connecting the +5V and ground pins? What about clocks etc?
Cheers