LiquidKernel
New Member
Hello everyone!
I am trying to figure out how this "Bulb Out" failure module works in my car. I opened it up and noticed a few SMT resistors (I assume they are shunt resistors) and an Analog Devices part.
AD
22006R
9504
96160
It is a 16 pin SOIC.
I could not find anything on AD22006R, but I did find some things for AD22057 which is a Single Supply Sensor Interface Amplifier. Seems like it's relevant because the data sheet shows this wired up as a current sensing device in an automotive application. However, it's a single supply one (8 pin device) whereas the one I have is 16 pins.
Thank you!
I am trying to figure out how this "Bulb Out" failure module works in my car. I opened it up and noticed a few SMT resistors (I assume they are shunt resistors) and an Analog Devices part.
AD
22006R
9504
96160
It is a 16 pin SOIC.
I could not find anything on AD22006R, but I did find some things for AD22057 which is a Single Supply Sensor Interface Amplifier. Seems like it's relevant because the data sheet shows this wired up as a current sensing device in an automotive application. However, it's a single supply one (8 pin device) whereas the one I have is 16 pins.
Thank you!