Adding EEprom to a PIC

Status
Not open for further replies.

Mosaic

Well-Known Member
Can anyone point me to a decent tut for adding EEPROm to a pic?

I might need a couple MBs

thx
 
Well have'nt figure that out.

Basically I am sampling music notes played on an instrument....determining the note (eg A B C..) and then storing it with a timestamp in Eprom to be read back out via serial over usb later.

I may need a dspic I am not sure.

What do u think?
 
EEPROM does have a 10mS delay which is significant at audio frequencies.The SDcard runs off the spi i/o not so?

Can I xmit data faster than 10mS per byte to SDcard?
 
With EEPROM you can write a minimum of 128 bytes every 5mS = 25k/s. SD card vary from 2M/s up to 10M/s.

Edit, an alternative might be Serial Flash that can write a byte in 7uS.

Mike.
 
Last edited:
That is not easy! How are you going to do that?

EPE magazine did just that a few years ago, using a low cost PIC 16C84 as a guitar tuner in 1997 - there's no need to store massive samples.


Source code is here:

**broken link removed**
 
Or, if you just want a guitar tuner and have an Android phone, install the free app called gstrings. Works wonderfully, I now just need to practice the guitar more.

Mike.
 
EPE magazine did just that a few years ago, using a low cost PIC 16C84 as a guitar tuner in 1997 - there's no need to store massive samples.


Source code is here:

**broken link removed**

Thx for that Nigel, it helps. But I need to store the notes and then upload em after a performance. Also, any idea where the schematic for that tuner might be found?
 
Thx for that Nigel, it helps. But I need to store the notes and then upload em after a performance. Also, any idea where the schematic for that tuner might be found?

It was in the magazine, which you can buy on-line as a PDF - unless you can find it posted somewhere?.
 
Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…