5 wire 110 v cap start with a relay is 1.5 hp

[Bobjoe]

Need some help wiring this motor,it is Emerson on a Delta saw around 1990 vintage. From frame 1 blue,1 red, 1 yellow,1black,1brown.they ohm out as follows black to white 1 ohm, yellow to white 1 ohm,black to white 5 ohms.there is a overload switch enter black wire from source . Then a relay enter common from source.there is a 240 mfd capacitor which has jumper from start relay. I wired per diag on mtr plate it ran very slow in reverse. This is a dual voltage mtr.

 

[Inquisitive]

Are you wiring 120V or 240V?

 

[Bobjoe]

120 volt,I disabled the coil operated motor brake,the coil is bad and must overcome a spring pressure to turn freely.