Thanks a lot Boncuk.
I tried having all my angles at 45 deg, except when switching layers.
These angles are not only cosmetic but also serve a function of having less reflections. I also read that when there is need to connect 3 signals it's best to form a "T" junction for better performance.
I didn't quiet get what you meant with D1 and what is the solder side ? If it's a double layered board doesn't it have solder on both sides ?
I'll play around with the grid a bit. Maybe i'll get rid of these ugly miss aligned vias.
Too bad I don't have a wide screen monitor, but a great tip nonetheless.
I just wanna make sure, is it ok to place vias like I did ? i.e really close to the IC pins or under the IC it self ect ?