I have an AD712 that has a 1K pot connected to its POS_2 input. After a while the POT is getting warm to touch. Am I not using the right value for POT?
POT is connected to 3,4,5 pins of the header shown in picture.
Supply voltage: ±15VDC
POT connections: Pin1 - -15VDC, Pin2 - POS_2, Pin3 - 15VDC
Any suggestions?
thanks
POT is connected to 3,4,5 pins of the header shown in picture.
Supply voltage: ±15VDC
POT connections: Pin1 - -15VDC, Pin2 - POS_2, Pin3 - 15VDC
Any suggestions?
thanks