Hi,
I read that the SPI SCK cant run too fast. I'm not sure if this is true, but I set the Program to
INT OSC 8MHz
osccon = %01110010
SSPCON1 = %0010000
Hi,
I read that the SPI SCK cant run too fast. I'm not sure if this is true, but I set the Program to
INT OSC 8MHz
osccon = %01110010
SSPCON1 = %0010000
Hi,
I spoke too soon, regarding getting the SPI SCK working, as it was working up to a certain point.
After much analysing, it turns out to be the second PIC on the same PCB, sending a tick, which stopped the SCL. I've turned off the second PIC for now, then I'll investigate later.