12f629 Code Ref for Stepper Function.

cybersky · Feb 12, 2012

Hi

I am building a stepper motor controller and would like to use the oshonsoft stepper funtion. However I cannot find an example of how to ref the "port" as the 12f629 only has GPx.

Code:

Define STEP_A_REG = GP5
Define STEP_A_BIT = 5
Define STEP_B_REG = GP4
Define STEP_B_BIT = 4
Define STEP_C_REG = GP0
Define STEP_C_BIT = 0
Define STEP_D_REG = GP1
Define STEP_D_BIT = 1

GP2 & GP3 will be Step & Dir

Perhaps a general tutorial on how to "substitute" Portx for GPx ?

Thanks

Ian Rogers · Feb 12, 2012

Code:

Define STEP_A_REG = GPIO
Define STEP_A_BIT = 5
Define STEP_B_REG = GPIO
Define STEP_B_BIT = 4
Define STEP_C_REG = GPIO
Define STEP_C_BIT = 1
Define STEP_D_REG = GPIO
Define STEP_D_BIT = 2
Define STEP_MODE = 2

GPIO is use for port access

cybersky · Feb 12, 2012

Thanks, so when i need to adapt Portx I use GPIO. New it had to be easy. Thanks again.

12f629 Code Ref for Stepper Function.

cybersky

Member

Ian Rogers

User Extraordinaire

cybersky

Member

Similar threads

12f629 Code Ref for Stepper Function.

cybersky

Member

Ian Rogers

User Extraordinaire

cybersky

Member

Similar threads

Privacy & Transparency

Privacy & Transparency