In our RF LNB, three LMX2594 RF synthesizers are connected to the Microcontroller SPI Bus. All three LMX2594 chips share the SPI CLK, MISO and MOSI lines (called SCK, MUXout and SDI in the datasheet). Each LMX2594 device has its Chip Select signal from the microcontroller (CSB). We can read and...
I am trying uart serial communication on pIC16F886 . I am using 20Mhz external oscillator frequency.For below code i am getting garbage value.
i have tested similar code on PIC18F24K40 where i am using 16Mz internal oscillator where i can able to send and receive data with same hardware . Here...
Hey guys,
I have some treadmills at they gym and some of them have a RJ45 connector. Is it possible to connect to the treadmill and READONLY the data like heart rate/speed/distance and so on? Any hints in starting this side project?
I believe that it might send some serial data through there...