Hi,
I recently bought a cheap hot air gun rework station. Maybe Chinese clone of 858D. I recently knew that the 858D is one of the popular rework station around the world.
Just using it few hours, now shows "732" or "733" few seconds then shows "H-E"or "S-E". Device is not working. Sometime it...
Hello,
I have a panel heater that stopped working. It's a large item, and a relatively basic electrical device. So rather than through it away, I'm going to try and fix it.
It has a relatively simply 2x1 inch component board in it.
What I have determined so far:
1. There is power reaching...
Hello,
I hope this isn't too far outside this forum's usual fare.
My pride and joy is a 1959 Morris Minor. As you can imagine, it has a pretty simple electrical system composed of mechanical relays and such, and usually I have no trouble working on it. However, I'm homebrewing some upgrades to...
Hello,
I am working on an aluminum gas sensor testing chamber, where I will need to apply up to 400 degree C to the sensor being tested. I am wondering what must be done to be able to control the temperature. The created the chamber and left an open area for insulation and nichrome wire...