I started the basics of PCB and doing schematics around 6 weeks ago in my Computer Engineering Drafting and Design class. We used EasyEDA online tool to create the SCH and PCB for our assignments/activities. Our project now is to combine the circuits that we have made before into one system so...
Hi. I need a little help from experienced people.
I want to control a Peltier element with a microcontroller, with PWM. May? The peltier element has the following parameters: Imax=8.5 A, Vmax=15.4V.Ok... I have a 12 volt source,17A for example.
How can i design the circuit so that i can...
Hello everyone,
I am kinda new to the website, I just came across it after looking for answers for such a long time.
I have an assignment that asks to add an input bit to your circuit from the circuit I created that goes up my sequence of 3 up to 15 called U (for up). If U is a 1, your circuit...
Hello,i need a help for this question.
3-bit up-down counter if input=1 count up else count down use JK Flip-Flop.Construct JK FF by using logic gates (Inverter,AND,OR,etc..)
Thx
Hi Team,
I want to represent a circuit diagram in a mathematical way (Not the electrical behavior of the components). Just the connections between different components. For example below this circuit is a diagrammatic representation of the connections between various components. How do I...
Hello guys,
I'm studying physics, but I have a project in my extra subject and I'm really in a hurry. My electronics knowledge is really basic and I'm stuck. So any help/ideas/discussion is very very appreciated. I have to make a project with at least 2 traffic lights (I don't really know...
I recently had the idea to build come kind of a solar-powered Arduino robot. I have a (relatively) powerful solar panel I'd like to use, but obviously it's nowhere near powerful enough to drive a motor in continuous operation.
The design I had in mind was a low-voltage solar panel (~2V on a...