Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
Thanks guys. This is exactly the type of help i was looking for. That's why I searched for this kind of site. Let me try these suggestions and get back to you with the results. Once again thanks for all the quick replies.
Carl,
The sensors work by detecting when the rim of the post the head swings on, passes between the slot (see attached picture. Bypassing the sensor won't compromise safety because the head is permanently locked in position so it no longer swings between two polishing platens.
Need help in figuring out work around
Thanks for the quick reply. I did not touch the LED's I worded it wrong. I meant I replaced the position sensors. Is it possible a LED is burned out or bad and could that be it. Can I jump the sensors so the machine thinks they are sensing the head is in...
Hi I'm brand new to this site and I have to admit I know very little about electronics circuits and so forth. I'm a metallurgist but I'm hoping someone can help me with an issue. Hope i can even explain it properly. I have a piece of polishing equipment. This equipment has a sensor to detect...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
